Haltech Wideband 02 Controller Quick Start Manual de usuario descargar pdf (Pagina 2)

Haltech Digital Display (HDD)

1. Connect the Serial OUT connection (unmarked) to the Serial IN connection of the

HDD1

(marked) with the included 2.5mm to 2.5mm cable.

2. Connect the terminator plug (2.5mm male plug with no cable) into the Serial IN

connection of the

HWC

Connection to Haltech ECU’s

The addition of the HWC to the Haltech Engine Management System will allow for far

greater tune ability and functionality. The HWC will allow the AFR to be monitored and

logged in real time, making it possible for accurate tuning to be done anywhere. All

Haltech ECU’s require the use of the Analog output 2 (0-5v signal).

For E8 and E11v2:

Using the

Brown

wire (Analog output 2), the

HWC

can be connected to either the

O2A wire (

Pin 12

on the 26Pin ECU Connector), or any of the Spare A/D channels.

Alternatively for easy installation, the

HWC

can be connected into the Spare A/D 2

(Trim connector found near the ECU connector), using the 4-pin connector.

For software setup please see the ECU instruction manual.

For E6X, F10X and E6GMX:

Using the

Brown

wire (Analog output 2), the

HWC

can be connected to the O2 wire

(

Pin 2

on the ECU Connector). Alternatively for easy installation, the HWC can be

connected into the Trim or Spare A/D connectors found near the ECU connector),

using the 4-pin connector.

For software setup please see the ECU instruction manual.

HALTECH HEAD OFFICE:

+612 9729 0999

+612 9729 0900

sales@haltech.com

HALTECH US OFFICE:

e. usa@haltech.com

See the Haltech website for your local authorised dealer.

www.haltech.com

WARNING

The Oxygen Sensor used in this device gets very hot in operation. Do not touch the hot sensor or

let hot sensor touch a co

mbustible surface. Do not use the sensor with or near ﬂ ammable liquids or

gasses. Failure to heed these warnings may result in severe burns, explosions or ﬁ res.

When installed in the exhaust, the oxygen sensor MUST be co

nnected and operate with the Haltech

wideband

Controller (HWC) whenever the car is running. An unpowered oxygen sensor will be

quickly da

maged when exposed to hot exhaust gases.

Haltech Wideband Controller

(HWC)

QUICK START GUIDE

1 2

Comentarios a estos manuales

Sin comentarios

Haltech Wideband 02 Controller Quick Start Manual de usuario Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Para El Coche Haltech Wideband 02 Controller Quick Start